1 / 7
Ender 3 S1 / Ender 3 S1 Pro - eSun filament dryer base (eBox) - Halterung eSun
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
What you see is what you get. :-)
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 110
- Wydruki
- 1
- Wyświetlenia
- 1105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (25)Powiązane
What you see is what you get. :-)
Data:
- For Ender 3 S1 or Ender 3 S1 Pro
- Screws: M5x10
- Solid construction
- Installation on the left side.
- The holder is supported by the lead screw bracket.
- Attention: I changed the postion of the filament sensor for a better feeding to the extruder. You get an other filament sensor holder on thingiverse.
Daten:
- Für Ender 3 S1 oder Ender 3 S1 Pro.
- Schrauben: M5x10.
- Belastbare Konstruktion.
- Wird auf der linken Seite montiert.
- Die Halterung wird zusätzlich durch die obere Leitspindelhalterung gestützt.
- Achtung: Ich habe die Position des Filamentsensors geändert, damit das Filament besser zum Extruder geführt wird. Andere Halter für den Filamentsensor findet man auf "thingiverse".
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
0.28
Infill:
25%
Filament: PLA
Category: 3D Printer Accessories