Bosch AL3620CV Charger Brackets (overhead remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix that allows the charger to be mounted overhead, to a ceiling, or under a surface.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 28
- Wydruki
- 1
- Wyświetlenia
- 486
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
This bracket modifies Andy Forsberg's design to allow mounting the charger under a surface, e.g. under a desk. The screws for lower_bracket can now be added after the charger is already in place, and the position of the screws is better suited to increase lateral stiffness required for overhead mounting.
Andy Forsberg kindly included his design files for the original brackets, which made remixing a lot easier. Unfortunately I wasn't able to re-create clean fillets everywhere.
Designed with upright printing in mind to avoid potential delamination problems once installed. There is one place near the end of the print that could use supports, but since that surface is not visible later I chose not to use supports.
Requires 2 pan-head size 4 screws, length 10mm + [distance that goes into the surface you're screwing into].