Isotherm Marine Refrigerator Lamp Base and Switch Plunger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement lamp base and switch plunger for an Isotherm Cruise 130 refrigerator and other 12 or 24 volt units
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
I created this model to replace the original lamp base and switch plunger in our Isotherm Cruise 130 marine refrigerator. The original melted when the plunger broke, leaving the light on when the door was closed. Where are kids to check that when you need them?
I printed in Prusament PETG on my MK4 using a 0.6mm nozzle and Input Shaper. Printing of the supports for the lamp base was not great, so the top surface of the support area was not smooth, which made them difficult to remove. Otherwise printed fine.
The original plunger length was estimated for the one I printed. It turned out to be about 2mm too long, and the spring force could cause the door to not close securely. I shortened the plunger in place. You can see in the photo the end of it has been modified. I corrected this in the model that I uploaded here.