Allen wrench / "hex key" T handles
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a simple set of T handles for smaller Allen wrenches (fits M1.5, M2, M2.5, and M3).
- Ocena
- 4,667 / 5
- Polubienia
- 76
- Pobrania
- 572
- Wydruki
- 4
- Wyświetlenia
- 5669
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Just a simple set of T handles for smaller Allen wrenches (fits M1.5, M2, M2.5, and M3).
Some are a bit tight, but that's intentional. Push your wrench in from the bottom, twisting as needed to "drill" through the tight plastic, and secure it in place with one or two M3 screws.
The nuts are a tight fit, so you may want to heat-set them with your soldering iron, or use longer-than-necessary screws to pull them into place before using a normal, shorter screw.
Print instructions
Licence: Creative Commons - Attribution - Non-Commercial - Share Alike Category: Hand Tools Print Settings
Printer Brand: Prusa
Printer: Prusa Clone
Rafts: No
Supports: No
Resolution: 0.2 mm
Infill: 20-30%