1 / 5
LEGO Technic Porsche 911 RSR #42096 Wall Mount (Spoiler Up) — zdjęcie 1
1 / 5

LEGO Technic Porsche 911 RSR #42096 Wall Mount (Spoiler Up)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

SpoilerUp Wall mount for LEGO Technic Porsche 911 RSR #42096, designed to used with Large Command Velcro Adhesive strips

Ocena
0 / 5
Polubienia
36
Pobrania
278
Wydruki
0
Wyświetlenia
3192
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Wall-mounted
Licencja
Creative Commons — Attribution — Noncommercial

Vertical Wall mount for LEGO Technic Porsche 911 RSR #42096 (Spoiler UP), 
designed to used with Large Command Velcro adhesive strips

Taking the 2 Black skid pads at the bottom helps it to sit closer to the wall
You can move the stickered flat plates in line and you can store them in the car so they won't get lost (Red Rectangles and interior in photos) 

Orange Markings for where the hooks go

Front Hook goes on the empty gray axle 

Back Hook goes on the gray beam frame

One Large strip is technically barely enough but it is so close to the carrying limit of single strip and had to tendency to push itself away from the wall because of weight distribution  

So I designed to have it hooked from 2 points and highly suggest using both to prevent it from falling on small impact,door slam etc. also this helps to keep the load vertical rather than having it in a angle. 

First Put the front hook so you can lean the away from wall and hook the rear and push towards the wall, take out the car apply force to stick the velcro properly

You can also support and see the rear hook from inside of the car easily when doors open 
(5th photo)

Tagi