1 / 12
Space Mushroom Remix: UFO style knob with LED light — zdjęcie 1
1 / 12

Space Mushroom Remix: UFO style knob with LED light

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of "Space Mushroom : Full 6 DOFs Space Mouse" by shiura - @shiura_250609 UFO style knob with LED light

Ocena
0 / 5
Polubienia
44
Pobrania
203
Wydruki
0
Wyświetlenia
3805
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

UFO style knob with LED light.

It's kind of huge, but comfortable in your palm. I print the knob with fuzzy skin & random seam position, result in nice seamless surface. 

  • You'll need a small push spring coil to better support the weight of the knob and your hand, as the springs of the 3 “analog joystick sensors with board” are too weak. Put the spring assembly (yellow pad + spring + yellow plug) on the triangle shaft under the knob, no need to screw or glue. 
  • To stabilize the base, I stick some thin lead strip inside the base perimeter. The base total weight about 200 grams including the arduino pro micro.
  • Base lights are 5 volts LED strips. I tap the power directly from the USB cable red (+) & black (-) internal wires.
  • The original triangle shaft & 3 ball-joints are printed in transparent filament to refract some led lights out.
  • Because it's hard to find tiny screws, I just stick the 3 “analog joystick sensors with board” to the shaft with double tape foam, then tied them with some single wire thin cables.  The shaft is screw from the bottom of the base (the original design have a threaded hole).

Tagi