Ender 5 Plus BTT TFT35 V3 External screen mount

External Screen mount for the BTT TFT35 V3 which gives you access to the usb port and SD card on the screen. If this was mounted inside the control box where the original screen was. You would not have access to the usb port or sd card that's on the screen. With this it gives you access to those ports. This is made for the Ender 5 Plus. 

This prints out in 3 parts. All are in the same file as multiple parts. The back bracket, the Box and the Lid

• The back bracket you will mount it inside where the oem screen was mounted. On this you will insert 4 - 4mm threaded inserts (Heat insert type). 
  • Screws to mount the bracket to the enclosure is M3x8 screws. 
• On the front/outside of the enclosure you will attach the box to the back bracket. Using 4mm screws into the threaded inserts that's on the back bracket. 
• Once you get the screen wired up, and in place it will use 3mm screws to mount it in the box. 
• Lid also uses 3mm screws. 

GCODE file is just for reference, do not use it to print. Especially if your ender 5 plus isn't setup for input shaping on marlin 2. 

Pictures attached, on the one picture that shows the wires coming into the box, the box is upside down in that picture. I forgot to take a new one when I corrected the orientation of the box.