Lego 75355 X-wing wall holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of wallmount holder for lego UCS X-wing.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 136
- Wydruki
- 1
- Wyświetlenia
- 1438
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Wall mount pieces for Lego set 75355 UCS X-Wing
3-piece set to mount Lego set to the wall.
Wall mount is angled in a way to show X-wing in flight, with enough clearance to allow all S-Foils to be locked in attack position.
3 pieces separated to allow for easier printing
- Print BackPiece on its side with screw holes parallel to print bed.
(Supports may be required for screw holes depending on printer settings.) - Print WallMount on its flat side .
- Print WallPiece with largest holes on the print bed. (Supports are needed)
Secure WallPiece part to the wall via suitable fixing.
Slot BackPiece into WallMount piece and align with WallPiece, 2 holes can be used to secure both pieces together with a suitable small nut and both.
BOM for not printed parts: 2x M4 nut with nylon ring
2x M4x16 (DIN 912)
2x suitable fixing material for your wall (dowel + screw)
Lego set sits securely atop the WallMount piece, the larger upright fits into the existing mount hole on the bottom fuselage of the set. Two additional smaller uprights fit snugly at the front and rear of the lower fuselage.