Drop BMR1 speaker monitor bezel/edge mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting brackets to attach Drop BMR1 speakers to outside bezel or screen edge of flat panel monitor
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 97
- Wydruki
- 1
- Wyświetlenia
- 945
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
As original designer @tedder_1424 suggested [thanks!] I stole the mounting panel geometry from the original design and replaced the rest with a narrow angled strip (about 0.6 x 7.75 in). If my CAD skills were stronger I would've tried contouring the mount to the back of the monitor housing but, alas…
On my monitor (LG 34WN80C UltraWide) this angle pitches the BMR1s slightly inward. They aren't very directional and because listen to them throughout the room I didn't aim them straight at the computer user's position.
3M Scotch Mount Extreme tape (similar to VHB) seems to have mounted them sturdily. 3M says to use 2 (square) inches per 1 lb mounted. Each speaker is ~0.8 lb or less, and each mount has over 4.5 sq in of tape surface. If/when they fall off, I'll update this entry. ;)
I printed mine in ASA on my Bambu Lab X1C, 0.2 mm layer height, 3 perimeter loops, 40% cubic infill. Make sure to use a brim or at least mouse ears on the narrow strip to prevent warping.
By the way - the little step in the mounting strip was intended to reference into a step in the side of the monitor. But it ended up so shallow, and the mounting tape bridged right over it - seems negligible.