1 / 6
Foscam R4S Holders for Prusa Enclosure — zdjęcie 1
1 / 6

Foscam R4S Holders for Prusa Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cradle with 2 arm types for the Foscam R4S camera. It all press fits together and wedges underneath the Prusa Enclosure.

Ocena
0 / 5
Polubienia
2
Pobrania
19
Wydruki
0
Wyświetlenia
149
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I use Foscam cameras to monitor my printers so created this Foscam R4S cradle and two types of arms that slides/wedges underneath the Prusa Enclosure. No glue or hardware to assemble, it all press fits together!

I expected to do multiple iterations to get the fit right but the first time through and everything was nice and tight! The Foscam slides into the high walled Cradle nicely (no wiggle room) and the Cradle and Arm have a press fit (0.001") assembly (can still be removed or cradle rotated about arm). The arm is sized with a slight taper to wedge between the Prusa Enclosure and the table it's on. 

No significant iterations other than:

  • Cradle has a slight cut away so the Reset Button doesn't get triggered when sliding in the camera.
  • Cradle has grills added underneath where the R4S camera has grills so heat can still be expelled.
  • Created a V2 of the Arm that keeps the R4S camera right against the Prusa Enclosure. I use both versions since the one that sticks out is ideal for my end printer where I angle it forward a bit so I can pan the camera to see the room too.

Printed all in PETG, 0.4" Nozzle, 0.2" Layer, and 15% Infill; Arms printed with Supports turned on. 

Tagi