1 / 6
Armrest Lock hole – Mitshubishi Montero/Pajero Sport — zdjęcie 1
1 / 6

Armrest Lock hole – Mitshubishi Montero/Pajero Sport

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Recreation of part# MB562552 for Frame K90

Ocena
0 / 5
Polubienia
6
Pobrania
74
Wydruki
0
Wyświetlenia
472
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

My first detailed model created based on provided measurements, as a request. First version has been printed, but not yet tested.

 

I printed the matching male part from plabs.cz (Thank you!) slightly modified to make rounded part 8mm wide.

 

Printer: Prusa MK2.5

Filament: Sunlu Black PLA+

Layer height: 0.2 on first print, 0.1 on second (side flaps came out better)

Support: painted-on organic support for bottom of side flaps and bulges

Infill: 100%

Nozzle temperature: 215° on first layer, 210° on others, 205° on small perimeters of male part (added temperature change as custom code for layer where speed is reduced by slicer)

Bed temperature: Sunlu recommends 70° for PLA+, so I used that.

For some reason, I usually struggle with elephant foot expansion, so I increased compensation parameter for it from .2 to .3 under Print Settings/Advanced in PrusaSlicer. Also, I had some bad experiences on my previous prints with small perimeter quality, so I usually decrease min print speed to 8 under Filament Settings/Cooling.

 

Edit: reprinted in PETG to hold up better in summer days inside the car. Print temps increased obviously.