Top Glass Riser integrated into Lid Handle for Bambu Lab
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Top Glass Riser integrated into Lid Handle for Bambu Lab Printers ( P1S / X1C / X1E )
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 475
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix info: I loved the original handle but I felt it had too little grip space for my fat fingers so I extended it a little bit, but kept flat space for a logo. Also added a bump on a riser leg to avoid damaging foam insulation.
ATTENTION: DO NOT USE WITH AMS ON TOP OF THE GLASS - its a lot of weight on single point of the plastic frame. I noticed mine was bending…
Copied from original:
Top Glass Riser integrated into Lid Handle for Bambu Lab Printers ( P1S / X1C / X1E )
This is a replacement for the original Handle on the Glass Hood for the P1 and X1 Series. It integrates a stand that you can flip over, to allow additional airflow without removing the Glass Hood. The hinge is printed in place and the surface area is left blank intentionally, its easy for you to add a logo on top, and I don't get legal issues 😜.
Installation
Just unscrew the original handle, and reuse the screws to install the replacement. Done.
I hope you enjoy the design, please leave a comment/rating if you enjoy it or share your feedback!