Cuisinart Immersion Blender End Guard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Non-Stick pot Guard for stick blender end (Model#: CSB-76BC)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 276
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this end guard to protect non-stick pots from the metal end of a Cuisinart Immersion Blender (Model#: csb-76bc).
As this guard may fit other immersion/stick blenders, the relevant dimensions are:
- Outside diameter of blender end: 63.4mm
- Inside diameter of end guard ring: 64mm
I have used this part on making applesauce and tomato sauce (which requires fairly high temperatures) and had no problems.
Printed with:
-PETG
-15% Infill
-No Supports if printed in default orientation (shown in first picture)
Note: PETG's Maximum Service Temperature is around 73C/163F. As this part is never under any load and requires temperatures well over boiling to print, It's my belief that even if it begins to deform, the part should still hold up as it is effectively using the blender end as support.
Also, there seems to be some debate about PETG being food safe. Use at your own discretion. (Either way, it's probably safer than eating chips of non-stick coating… ;)