Ryobi 18V Quick Battery Tap Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
To tap Ryobi 18V simply slip this quick adapter over your battery and slide in fork/spade connectors crimped to wires.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 124
- Wydruki
- 1
- Wyświetlenia
- 675
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a very simple little adapter - so simple, in fact, that I was surprised it didn't already exist.
Usually, for these Ryobi battery adapter you'll have to buy some ryobi component to make contact with the battery terminals - I needed something quick (to print and implement) using things I had on-hand - which were plenty of spade/fork terminals.
This little widget prints in 6 minutes and all you do is slip it over your battery and slide in your positive/negative wires that have been crimped with spade terminals (need to be <8mm wide). The tolerance is pretty tight - but I prefer a tight fit for the connection than something too loose.
This is obviously not intended for use where you'll need to move the battery around - this is for situations where the battery can stay stationary and you want to tap its voltage. In one of the images I've got it hooked up to a step-down puck so I could power another device with lower voltage requirements…