Shendrones Squirt V2 - HDZero Freestyle V2 Kit Upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A HDZero Freestyle V2 VTX and Radiomaster RP1 Mount for The Shendrones Squirt V2 or similar stand off spacings.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 343
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I wanted to put a HDZero Freestyle V2 VTX Kit into my Shendrones Squirt V2.
This is the result.
You can still easily access the firmware upgrade port as it will be on the top.
I am using slimmer slammed 76mm ducts so not sure if this will require some modification.
(THE ORIGINAL SLAMMED SQUIRT By DroneCoProductions.com - SLAMMED_SQUIRT_DUCT_76MM_PROP)
Printed with 80% Infill.
If you happen to have a drone with similar spacing you can use this on it too I guess, here are the measurements for hole spacing and things.
I used the "Shendrones Squirt - DJI FPV USB-C Dust Cover" by “@FlyByTom” as a reference for size, mostly the hole spacing for the standoff slide on pieces.
- Top Back Antenna Piece = 10mm Height, 27mm between center circles, 5.6mm internal diameter, 8.1 outer diameter.
- Back Bottom = 20mm Height, 27mm between center circles, 5.6mm internal diameter, 8.1 outer diameter.
- HDZero Freestyle V2 VTX fits tightly into back TPU piece.
- Slip into place, was secure enough for me.
- HDZero Nano 90 Camera holder with slight possible protection.
- HDZero RHCP Antenna mount
- Will require cutting down the middle to fit in and possibly a zip tie depending on tightness.
- My ELRS Antenna was zip tied on in three places, I should have made the T Bar thicker.
UPDATE:
I made the Antenna mount much better, please use this one and not the old one.
