Box Corner Spout Nozzle and Cap (For 20 Mule Team Borax)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Do you use borax ? Do you hate that you can't re-seal the box? This is the print for you !
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 217
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I modeled this funky shaped funnel / nozzle and cap to glue on to a 20 Mule Team borax box I use for laundry because I got tired of it spilling out of the hole you punch in the side of the box.
The critical dimension is 52mm so it should fit any boxes close to that width, and glue is a must or the powder will eventually still spill. I used E6000 glue for flexibility, but I imagine any glue will work. Make sure you have “print thin walls” or the equivalent setting turned on as there is a thin wall near the bottom of the spout. Printed in PLA+, 0.4 nozzle, 0.24 layers.
Donations welcome:
https://buymeacoffee.com/bulgogi19