3M Adflo to Milwaukee M12 Battery Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Can be used to run a 3M Adflo fresh air motor unit from a Milwaukee M12 Battery
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 217
- Wydruki
- 0
- Wyświetlenia
- 2176
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Can be used to run 3M adflo from Milwaukee M12 battery.
To assemble you need to solder some wires and crimp some spade connectors.
Use Large 6.3mm spade connectors for the Milwaukee battery side
Use small 2.8mm male spade connectors for the 3M Adflo side
MAKE SURE YOU DON'T MESS UP THE POLARITY
Measure twice, test once. Forget to measure and you will blow up the PCB of the adflo unit (I speak from experience here) and need to buy a new (second hand) one.
I used a soldering iron to melt the spades into place. I used CA glue to glue to combine the two parts (milwaukee holder & adflo side).
My clip broke off at the first try, but it was quite a snug fit without it already so it works fine without.
Notice that I use only the battery positive and negative terminals, other terminals are not used.
Prints fine with arachne and 0.6mm nozzle in current prusaslicer version with input shaping.