Thermoworks Pro-Series Food Probe Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This probe holder is designed specifically to alleviate cable strain. The food probes are fairly long in both…
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 146
- Wydruki
- 2
- Wyświetlenia
- 575
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
This probe holder is designed specifically to alleviate cable strain. The food probes are fairly long in both dimensions. As a result many of the other probe holders I've seen are too small and cause excessive cable strain to store the wire. So pay particular attention to how the Food Probes are stored on the Food Probe holders as they can basically fit in any direction you want but only one direction keeps it from bending the wire too much. The width of the holder should be narrow enough to hold the plug end of the probe in if you have the silicone color ring on it.
This is part of the a complete storage solution for the Thermoworks Signals system. https://www.printables.com/model/758475-thermoworks-signals-system-holder
A similar holder for the Pro-Series Ambient Air Probe is available here: https://www.printables.com/model/758473-thermoworks-pro-series-ambient-probe-holder
Print Settings
Printer Brand:
Bambulabs
Printer:
Bambu X1C
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
15%
Filament: Sunlu PLA Any
Notes:
I use a brim on this print just to hold the one island of the other side of the probe clip until they join further up. You may or may not need it.
Category: Kitchen & Dining