1 / 1
Duet3D filament monitor V3 with secure air fitting — zdjęcie 1

Duet3D filament monitor V3 with secure air fitting

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Includes a threaded section to accept a 10mm air fitting.

Ocena
0 / 5
Polubienia
0
Pobrania
13
Wydruki
0
Wyświetlenia
109
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I found the original tube clamps to be a little problematic when changing filament, I would often pull the tube out of the monitor. By fitting a 10mm thread, pass through tube connector, the PTFE tubing still follows the same path as the original but is held more securely. Only one connector is needed as the extruder holds the other side.

Advised to print using resin, if upgrading an existing model only the white part in teh picture is needed to be reprinted (for V3 sensors).

Tagi