Skadis Mount for Netgear GS108Tv2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting plate for attaching a my switch to a Skadis pegboard panel.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 294
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I've used a Skadis pegboard as the backplate for my network cupboard for a while. I had used velcro to attach all of my devices - but my Netgear GS108Tv2 switch is heavy enough that it has been sinking over time, so I've made a mounting bracket specifically for it.
I used CSD_Salzburg's “Universal Skadis Clip” system from the model that I've marked this a remix of, but included the sources of the clip (I remodelled it to check dimensions, and have included STEP here). Two of these need to be printed - the fit should be tight.
I printed this on in PETG, and it's side, to try and avoid horizontal weakness since the switch is somewhat heavy and it gets pretty warm in the cupboard. This required ~25g of support material, and I forgot to support the long vertical spurs at the front (you can see the vibration affecting the print in the bottom-right of the picture).
I haven't tested printing it upright, but I'm probably being overly paranoid - printing upright will probably required support on the horizontal spurs on the side panels.