Ender 3 V3 SE Glass Print Bed Clips
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bed clips for the Ender 3 V3 SE when upgrading to the Creality glass print bed.
- Ocena
- 4,5 / 5
- Polubienia
- 70
- Pobrania
- 641
- Wydruki
- 3
- Wyświetlenia
- 3175
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple 3D printed bed clips for the ender 3 v3 se glass print bed (from creality).
You should consider printing them with PETG if you use high bed temps. However, I have printed them with PLA because I usually print with PLA and my bed temps are only ever at 60 C. Even so, they have been holding up very well (no deformation) despite being used with the heated bed.
CAUTION: These clips have not been thoroughly tested at higher than default speeds. Given that the ender 3 v3 se is a bed slinger, you should use caution when printing faster than default, as the clips could potentially come loose/off. I normally use a 0.6mm nozzle, thus my printing speeds are never higher than the default, so just be smart when using these or use them as a temporary solution.
Printing Instructions:
Print both files twice, as each file has 1 clip and you need 4.
Print parts 100% solid.
Make sure to orient parts correctly to avoid overhangs. (As shown in picture above.)
Depending on the tolerance of your printer you may need to uniformly scale these parts up or down to get a snug fit. The files listed below is what I needed to get the right fit using a 0.6mm nozzle. (Yours may vary)
Other than that, its a very straightforward and simple print.
Both STL and STEP files available below.