1 / 2
64x32 LED Matrix w/ Pi Housing
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a two-part housing for a cheap 64x32 LED matrix, including mounting for a Raspberry Pi 3A+…
- Ocena
- 0 / 5
- Polubienia
- 46
- Pobrania
- 465
- Wydruki
- 0
- Wyświetlenia
- 3587
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 4)Remiksy (1)Kolekcje (81)Powiązane
This is a two-part housing for a cheap 64x32 LED matrix, including mounting for a Raspberry Pi 3A+
BOM
- 1x 192x96mm LED panel like this one. Unfortunately, this listing makes no guarantee of screw hole locations, however I've ordered several panels and they have all been the same so far.
- 1x 198x102mm acrylic piece for the front.
- 1x Raspberry Pi 3A+
- 1x XT30 for power.
- 6x M3-10mm button-head screws.
- 2x M3 nuts.
Build Notes
- To get the Pi to fit, you will need to remove the large power connector and solder cables on directly.
- The Pi sits upside down, facing into the matrix.
- The Pi mount is offset a little bit to clear some capacitors if you are using a makeshift hat.
- The screws pass through the back casing, through the front casing, and into the LED matrix, holding the whole thing together.
- The acrylic piece should press fit in. You might need to sand it a little!
- Use this library to start displaying things: [rpi-rgb-led-matrix](https://github.com/hzeller/rpi-rgb-led-matrix/}.
Print Settings
Resolution:
0.1-0.2mm
Infill:
10-20%
Filament:
Generic PLA
Notes:
For the front, print with the screw holes, etc. on the bed.
For the back, print with the back panel on the bed, with supports for the screw holes. You may have to play around with the supports to get them not to stick. I had to drill mine out in the end.Category: Gadgets