1 / 3
20x20mm (M2) to 30.5x30.5mm (M3) Adapter for Micro Flight Controllers — zdjęcie 1
1 / 3

20x20mm (M2) to 30.5x30.5mm (M3) Adapter for Micro Flight Controllers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a bit of a re-imagining of https://www.thingiverse.com/thing:1610834 --- thanks for the inspiration! My main…

Ocena
0 / 5
Polubienia
5
Pobrania
59
Wydruki
0
Wyświetlenia
298
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

This is a bit of a re-imagining of https://www.thingiverse.com/thing:1610834 --- thanks for the inspiration!

My main need was for M2 holes instead of M3, and I also wanted to offset the M2 portion so I could bolt it together properly.

Print it, stick your M2 bolts pointing upwards and attach your stack as normal as if it were the bottom of the frame. Put the whole thing on the frame and screw your M3 bolts upwards, secure with a nut.

The total height is 4mm, where the M2 section is 2mm. You can just squeeze in a socket cap M2 screw.

UPDATE (05/05/2017):

I've made a newer version with thinner walls, enough to get out of the way of your board so you don't need lower standoffs. There are also half and quarter versions if you find you are in the way of your battery strap holes or similar.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Clone

Resolution:

0.25mm

Infill:

100%

Notes:

I printed it (M2 holes against the bed) with support. The opposite might work better for you.

Category: R/C Vehicles

Tagi