A/C Infinity 6" to 8" adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made an adapter to go from the 6" fan to the 8" Damper.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
I created an adapter for my A/C Infinity 6" fan to go to the 8" damper. I ordered all the 8" exhaust stuff to drop the exhaust back pressure so I could pipe more than one laser into it without having multiple exhaust ports going through the house. The 8" side fits very snug. I get a bit of a lip printing that side down but one fast go around with sand paper allowed it to slide on tight. On the 6" side it's a looser fit. I don't have any issue with the fan sitting vertically but if I were to have it horizontal it might be to loose. I wanted it to slide off easily so i could have toolless access to the fan to clean it. I also wrapped a couple of layers of electrical tape to act as a seal and it made it fit nice and snug so that's always an option. Note this is only designed to be female on both sides so I don't believe piping would fit over either side of it.
