6.35mm Guitar Pedal Potentiometer Knob
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Potentiometer Knob for Guitar FX Pedals that have narrowly-spaced round 6.35mm shafts
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 309
- Wydruki
- 1
- Wyświetlenia
- 1133
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Oct 25 2025
I adjusted the design to allow for more room to add the threaded inserts, and I added a 3mm hole to make it less messy to add the M2 inserts.
Here is the OnShape layout. I have created a variable table so you can really customize the knob .. more holes? Yep. More contour? Yep.
Specifically built for DIY guitar pedals with narrow spacing between knobs like FuzzDog and others. Knob has indentions for grabbing, plus a shallow notch dug out to show the dial position.
These knobs are made for smooth, rounded pot shafts. It won't be a perfectly snug fit because I don't want any pot damage. It's possible to mash too hard and damage the pot. You will want to melt in an M2 H4 threaded insert for a set screw. Don't push too hard and keep an eye on the inside of the knob because once you break through to the void, it will go in too far. I guess you can even slide it on a pot and mash the insert. until it hits the shaft of the pot.
Printing Instructions
Print it with the hole facing upward. Units are in mm. The slicer will complain about unsupported sections. The only place you might want to put a support is where the hole is for the threaded inserts. There is the possibility the indent notch at the top of the knob might not print. I may need to make a more prominent recess there…. or you can adjust it to taste since I have linked the original document.