RunCam2 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
Printable replacement for the RunCam2 case.
I went through many iterations tuning the snap fit geometry to both hold the camera well, yet also allow it to release relatively easily. I decided to leave out the thumb tab release as I found it to be awkward and difficult to access, just push the camera out firmly and it will release.
Also included is a GoPro mount adapter that snaps into the case. This allows you to mount the RunCam2 to any GoPro compatible mount/accessory.
The case prints well in PETG, 100% infill, no supports. It would probably work ok in PLA but the release might be a bit stiff.
The GoPro mount was a remix of https://www.thingiverse.com/thing:2092007