K1/K1C/K1 Max/Ender 5 S1 filament runout sensor mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mod is to correct an issue with the filament getting stopped while trying to load.
- Ocena
- 0 / 5
- Polubienia
- 78
- Pobrania
- 335
- Wydruki
- 0
- Wyświetlenia
- 6489
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This mod corrects a filament path issue due to the bearing and the ~9mm gap for using that bearing.
Note: Creality uses this same sensor on other printers like the Ender 5 S1 and maybe others, so this should fix the same problem.
K1 Max users should use a filament that can withstand their chamber temp since the runout sensor is inside the chamber.
K1/K1C/Ender 5 S1 users should be able to use any filament since the runout sensor is on the exterior.
Try the (offset filament path) version first.
- Remove the PTFE bushing and clip.
- See photos for the locations of the snap close tabs to release to open the sensor case.
- Be careful not to let the spring jump out while opening the case; you may not find it again. I am still looking for one.
- Remove only the bearing shown in the photos.
- Install the printed part in the same location as the bearing removed.
- Close the case and reinstall the PTFE bushing and clip.
You will feel resistance when loading the filament; just push past it; it is the small roller on the sensor arm. You shouldn't have any more loading issues at the moded filament sensor.