Guppyscreen Nebula Pad Holder - Standalone
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
holder for the nebula pad with guppyscreen - pad rotated 90 degrees
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 145
- Wydruki
- 0
- Wyświetlenia
- 1272
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
standalone nebula pad holder (rotated 90 degrees) for this cool project → https://github.com/ballaswag/guppyscreen
IDC 10 pin 2,54mm male/female extension cable do work to extend the Nebula cable →
https://www.ebay.com/itm/272617069892?var=571737481000
Alternative - the Nebula Pad cable is attached to the mainboard on the left side of the printer and is approx. 30cm longer if you lead it out to the left side of the printer. All you have to do is make a small opening in the base plate (don't forget to deburr to pretend the cable to being damaged)
you can attach the holder with double-sided tape but if you will, i added 2 screw holes on the back for extra amount of hold
having problems getting the pins in? just print them longer about 1-2% (change the Z axis only!)
may the best way to print is like shown below
