Lawnmower cable clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip to hold the cables on a Craftsmen lawnmower handle. Lawnmower did not have anything holding the cables, so…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 283
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
Clip to hold the cables on a Craftsmen lawnmower handle. Lawnmower did not have anything holding the cables, so someone zip tied the cables tight to the handle. When the handle was folded up, the cables were over stretched and snapped. After replacing the cables, I made this to hold the cables in place but still allow them to move when the handle is folded.
Instructions
Should print on just about any printer. I had good luck with 3mm filament and 40% infill. Flexed enough to snap on tight without too much force. Stiff enough to stay in place.
Category: 3D Printing