1 / 2
Brickatinny
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Brickatinny: when you wanna brick up your dart blaster's picatinny rails.
- Ocena
- 0 / 5
- Polubienia
- 40
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 894
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 3)Remiksy (0)Kolekcje (32)Powiązane
Brickatinny: for when you wanna brick up your blaster's picatinny rails. Impractical? Yes. Fun? Oh, also very yes.
Fits any standard Technic brick. Minimum brick length is a 3x1, maximum is whatever you got the space for.
Required Hardware:
- 2x - M3 30mm Socket Head bolts
- 2x - M3 Nuts
Notes:
- STL's are oriented for printing.
- No supports should be required.
- Outer brim might be a good idea since there's some thin areas in the first layer.
- Minimum of 3 walls, 15% gyroid infill. But there's not a whole lot of difference in print time or filament use by just going ahead and using 5 walls and 20%
- The nut recess on the “Short Block - Nut Side” is a slight press-fit. I managed fine, but you may or may not need to lightly file it or trim the opening with an exacto knife if having issues.
What I used:
- Printer: Bambu X1C
- Filament: Inland PLA+ Gray
- Layer Height: 0.20mm
- Walls: 5
- Top Layers: 5
- Bottom Layers: 5
- Infill: 20% Gyroid
Again, can probably get away with like 3 walls, 3 top/bottom layers, and 15% gyroid … but I didn't notice enough of a diff between that and what I used to really care.