12G 20G Shotgun choke boxes

12G and 20G Shotgun Choke Boxes

Fully printable one piece design.

Long choke boxes

• for chokes up to 90mm (3.5 inches) in length.

• Minimum print bed size length 238mm width up to 120mm 12 Gauge - 6, 8 or 10 choke boxes
  20 Gauge - 8 choke box

  Regular choke boxes

---

• for chokes up to 76mm (3 inches) in length.

• Minimum print bed size length 208mm width up to 120mm 12 Gauge - 6, 8 or 10 choke boxes
  20 Gauge - 8 choke box

  Short choke boxes

---

• for chokes up to 63mm (2.5 inches) in length.

• Minimum print bed size length 187mm width up to 120mm 12 Gauge - 6, 8 or 10 choke boxes
  20 Gauge - 8 choke box

  If you need other sizes then please send me a message and do not forget to "tip designer" to support my work!

  My other boxes in this series:
  General purpose empty hinged box Thing 3644340
  Various partitioned boxes with trays Thing 3649139

  Printing

  The boxes have a large area in contact with the print bed which can encourage lifting of the edges and warping of the print. Ensure that you have a good coat of adhesive on the print bed. If you have a heated bed then it should be hot. I use 50c for PLA, 80c for PETG and 90c for ABS.
  The hinge pins have 0.5mm tolerance. I found that printing in PLA caused the hinges to stick however they can be freed easily with a bit of gentle force. The hinges print well in PETG or ABS (recommended).
  The box is designed not to require support. Do not use support as it may clog the hinges,
  0.25mm layer hight is recommended.
  The catch is designed to be secure so that the box does not open accidentally. You may need to adjust the catch with a file or sandpaper if it is too tight for your requirements.

  Print Settings

Rafts:

No

Supports:

Resolution:

0.25 layer height

Infill:

Filament:

Any Any filament but ABS recommended

Category: Sport & Outdoors