Lightweight base for Zowie ZA13-C

Replacement baseplate for original PCB, might need to scale by <1% depending on your printers accuracy and used material.

Cut out version is around 5.65cm^3, honeycomb is 5.97cm^3. Printing it with should give approx 6g and 6.4g in terms of weight (printed with PA12-CF15, 1.07g/cm^3).

Honeycomb version should be compatible with all most popular skates, including the bigger ones like GPX/GPX2 (front skate is a bit too wide but shush, it works).


Printing:
I recommend 0.12mm layer height (can go lower) and 0.4-0.5mm line width. For honeycomb 0.4mm is necessary due to honeycomb structure. 
Something stiffer like PA-CF works good, it's also less dense than anything based on PLA so IMHO it's a good choice.
Infill doesn't matter, can make it 100%.

SUPPORTS ARE NEEDED ONLY FOR CABLE HOLDER AND ONE BOTTOM SCREWHOLE, everything else should print perfectly.

Assembly:
IMPORTANT!!!! Depending on how u screw in the inner bracket there might be too much or way too little travel on the side buttons, putting it somewhere in the middle gives best results (with 0.4mm line width, results vary due to tolerances or used line width). 

You may need too widen the holes a bit, using a screw and some force will do just fine :)))

Make sure the bracket lays flat on the PCB and is not flexed in any way - this will guarantee good travel and overall feel on the main clicks.

Known issues:
- sensor z distance and base hole is not perfectly up to spec, there might be some issues with lower LODs
- pushing the shell in below back side button makes it click (i have no clue how to fix it🗿)

If any other issues come up or you have any questions, please DM me on Twitter (@dpplgngrz) or Discord (dissatsfaction), I will answer all of them ASAP :)
Replacement base for OP1 8K internals is coming soon!