Festool OFK 500 redesigned vacuum shroud low profile V1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My redesigned vacuum shroud for the OFK 500. It is low profile 17mm hight from base plate
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 327
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
With this vacuum schroud you can finnaly go around the material when it is placed on the table. The original design from festool is to high and will not work, not even with 40mm material… So i designed a new (in my opinion better) version. It is low profile and will work with material thickness of 18mm and up. The clearance is 17mm so maybe 17mm metrial will work as well.
Please post message if you need help with slicer setting or maybe if anything should be designed different. It is my first design so lots to learn.
Print settings:
0.2 layer
4+ walls
40% infill (i tryed both Gyroid and rectilinear both seem just fine after some use)
Support needed for the overhanging parts and also the pipe inside.