1 / 2
Air Horn Mount for Bicycle
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple mount for attaching an obnoxious air horn mini canister to the front of a bicycle
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 1212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (17)Powiązane
This is a simple mount for attaching an obnoxious air horn mini canister to the front of a bicycle, such as the Ozark Trail 3.5oz for marine use. The canister measures ~26mm in diameter. The front bicycle post is ~46mm in diameter.
Print Settings
Rafts: No
Supports: No
Resolution: 200
Infill: 15
Filament: PLA or PETG
Notes:
You will also need:
- Air Horn, 3.5oz (or otherwise 25-26mm in diameter) canister
- Elastic Shock Cord 3.375mm (1/8in) diameter, ~30cm (~12in) length will give plenty of excess. Feed it through the two holes from the top. Tie a knot on one end, then once you figure out how much you need tie a knot on the other side and cut off any excess.
- Velcro One-Wrap 19mm (0.75in) wide, ~30cm (~12in) length will give plenty of excess. One shorter piece will feed through the slot and wrap around the air horn can, the longer piece will feed through the other slot and wrap around the bicycle front post.
- Adhesive-backed foam or some other form of padding to keep the mount from sliding around and marring your bicycle.