Sovol SV07 Klipper screen cooler

This is a cooler for Sovol Klipper Screen on Sovol SV07 Plus. I dont have any personal experience with non plus SV07 but I do believe the screen and the mount is the same. This model uses the original mount and is connected to the fan connector on the Screen. Check first if yours has it. I believe initial models do not. Check the terminals on the connector and if they correspond to your fans connector. I had to swap mine around. Now you will need a 4010 blower fan from an old printer of yours. I have used a 24V one because I am not sure about the output voltage and I didnt bother measuring it. There is a channel for your cables on the model and then  you can fish your cables through the breathing holes and solder back together once you pull them through. Depending on the thickness of your cables. U may need to do a bit of DIY. Keep in mind that this was a fast designed model. One evening job. So the fit and finish isnt perfect. Holes are not perfectly alligned but they work. Use M3X20 bolts for mounting, fan doesnt need any. Havent tested for temps yet. Feel free to remix, update and share. I am open to any suggestions on what to improve as well. I printed it in about 20-25 minutes on the SV07 Plus with 0.25 layer height.

Update: idle temp 40 ( 60 before) 45-50 while running