E-ink 7" case developed for zivyobraz.eu (Michael -notches version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A complete solution for a wall or desktop display based on e-ink technology. More on the website zivyobraz.eu
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 61
- Wydruki
- 1
- Wyświetlenia
- 639
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Use any printing material. PLA seems best.
Print settings are nozzle 0.4mm and layer 0.2mm or 0.15mm.
The frame fits all common 7" e-inks. The control board is specially used based on esp32 - ESP-INK.
Description of the connection, uploading the firmware is on the website zivyobraz.eu
Installation is without tools. The printed "pushpin" tool or a thin 2mm screwdriver can be used for disassembly. It is better to drill the side disassembly holes with a 2mm drill after printing.
The model can be printed with a support leg to be placed on a table or a bar to be screwed to the wall. The purpose of this is to create a gap between the wall and the frame for free air flow in case you use a sensor (for example, temperature or dust). Otherwise, it is possible to hang without a rail directly behind one of the holes.
Thanks to Mr. @MultiTricker for valuable advice and comments during development.