SMD Magazine Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SMD Magazine featuring DIN-rail mounting, press-fit lid, dual labels, improved peeler and parametric sources.
- Ocena
- 5 / 5
- Polubienia
- 88
- Pobrania
- 421
- Wydruki
- 3
- Wyświetlenia
- 2008
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This my take on the SMD Component Magazine.
This version features
- DIN-Rail mount with printed flexure
- Press-fit lid to prevent accidents, can optionally be secured with a screw
- Easy one handed operation by pulling the protective foil backwards
- Two flat spots perfect for labeling (templates included!)
- Parametric source files for easy editing
Hardware
The lid can optionally be secured with an M3x4mm heat-set insert and 5+mm M3 screw.
It isn't required, however, as the lid by itself is already quite snug.
Print settings
I printed mine with 2 walls at 10% Infill and 3 top/bottom layers; 0.28mm layer height and 0.5mm line width.
The design uses 0.1mm tolerances for the press fit, so if your printer can't achieve those I suggest editing the Fusion360 design and increasing tolerance_loose (for the tape) and tolerance_tight (for the lid).
I recommend using ironing or a quick pass with sandpaper to take off any spiky bits, though it also works alright without this.
Make sure to place your Z-seams so they don't rub on the tape, check that the Z-seam on the body and lid are in different spots, and also reinforce the flexure with some additional walls.
Suggested placement: