Case for dummy load 150W 200V 20A
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Finished version of a great model from Dmitriy Rossolov.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 104
- Wydruki
- 2
- Wyświetlenia
- 530
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
I recently ordered this electronic load from Aliexpress (200V 150W Adjustable Constant Current Electronic Load Battery USB Tester DC 12V 24V Lead-acid lithium Discharge Capacity Meter), and I was surprised there is no available case for it.
After a few days of desperate browsing the internet, I found a brilliant model from Dmitriy Rossolov on grabcad.com. I immediately tried to print, but the STLs were corrupted, and some little details were off.
Fortunately, Dimitry published the STEP file (so do I here) and I could easily do all the modifications that moved this alpha model to a fully functional print.
Printing
In general, no supports are needed, the thin bridge over the USB ports on the lower part is an easy bridge.
For the panel part, I had better results with using supports for the thin part near screw terminals, but it works fine with just bridges too.
I've chosen PET-G for better temperature stability.
Assembly
- 4x M3x16 + nuts for attaching the PCB to the frame (I recommend using paper washers that used to be used in PCs).
- 5x M3x20 for the bottom part of the panel part.
- 6x M3x25 for attaching the upper part (fan cover).
- Thermal paste