Geodesic Dome Cat House Bed Parts (Remix)

Remix of the geodesic cat bed base by Abby575 that concentrates on adding strength and stability. Model was strengthened and then options to print fewer parts with their collective strength improving base strength also provided.

Details of the difference between the original and this remix:

• I found the feet to be questionable in their structural integrity just being open hollow triangles - my cats are aggressive little 2 year olds and would eventually find a way to stress the plastic so I made those beefier.
• The connections from the adapter to the bed and the floor items shared a fillet that introduced a point prone for snapping (in my humble opinion) so i removed it to add strength across that connection.
• The item is printed 6 times to complete the base, as it comprises the entirety of the base I see no reason to add complexity to the item by adding a “B” emboss and removed it.
• ONLY FOR THOSE WITH LARGE FORMAT PRINTERS: added a single piece with all 6 pieces fused into a single component to increase convenience and strength/stability. Note that you will want something to the tune of a 300x300mm bed to make this fit, I was able to rotate to to get one length as small as 292mm and as long as 297mm, so beware that your rotation matters if you are exactly at 300, this may push it to the limits.
• For the mere mortals among us restricted to 250mm print beds and lower, but wanting something closer to the single piece, also added a 2 piece and 3 piece variant that will add less bend/flex to the build while also fitting the print bed.

Instructions:

1. Print and build the entire geodesic cat dome by Abby575
   1. Instructions can be found at: https://www.instructables.com/Geodesic-Dome-Cat-House-3D-Printed/
2. Print base parts in one of the following:
   1. For single piece (large format printers only): print the one part
   2. For the 3 parts: print two and zip tie together
   3. For the 2 parts: print three and zip tie together
   4. for the single part: print 6 and zip tie together
3. Zip tie it to the geodesic dome in the configuration depicted on original post (Abby575's original image provided to avoid a link going dead):

IMPORTANT! If you are building the dome with the intent to turn it into the bed instead, the opening placement as depicted above is different. The image above shows the opening where it needs to be for the dome in the top left, top right shows the reconfiguration for the bed, bottom right shows it flipped on its side to connect the base, bottom left shows the completed bed upright ready for use.