Stage Lighting Wrench for C-Clamps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small wrench for adjusting stage lighting C-Clamp bolts on stage lights.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 368
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
A small stage lighting wrench for adjusting bolts on lighting clamps & yokes. The goal was to create a simple lighting wrench for adjusting state lights with the ETC C-Clamp at shows.
I wanted to make the wrench shorter than the TSA tool requirement of 7 inches and be small to fit in a Pelican case, so this is 5.16" (131mm) and a little less than ¾" thick (18mm).
Includes the following:
- 5/16" Square
- ½" Square
- ¼" Hex Bit Driver in the Tip
- ¼" Hex
- 3/8 Hex
- ½" Hex
- 5/8" Hex
- ¾" Hex
I printed in Polymaker PolyLite PLA Pro with 3mm thick walls, 3mm thick top and bottom, 40% line infill, and 0.2mm layer height. The wrench is surprisingly strong in the PLA Pro and I have no problem adjusting the bolts on a C-Clamp.