Traxxas Slash 4x4 Drift Wheel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drift wheel made to fit the 1/10 scale Traxxas Slash 4x4
- Ocena
- 1 / 5
- Polubienia
- 32
- Pobrania
- 229
- Wydruki
- 0
- Wyświetlenia
- 1124
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I tried ESylin's drift wheel (https://www.thingiverse.com/thing:1334558) and they worked great, just wanted some that are a closer diameter to the stock tires so I drew these up.
This design is for use with 12mm hexes, which the Slash 4x4 comes stock with. These should also fit in the rear of 2wd Slash models.
I printed these in PLA with .25 layer height with only 2 walls and 10% infill. I tested them out on somewhat rough pavement and got 2 full runs out of them before they were used up. If you want them to last longer, more walls would definitely help or printing in another material.
I was able to print these face down with no support on my Monoprice Maker Ultimate.