1 / 2
USB C Sony Minidisc Player Dock (MZ-E630 and other nickel gumstick models) — zdjęcie 1
1 / 2

USB C Sony Minidisc Player Dock (MZ-E630 and other nickel gumstick models)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a homemade charging dock for a Sony MZ-E630 MD Player also compatible with similar models that use NiMH gumstick

Ocena
0 / 5
Polubienia
4
Pobrania
38
Wydruki
0
Wyświetlenia
712
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution

This is a homemade USBC charging dock for a Sony MZ-E630 MD Player, also compatible with similar models that use a rechargeable NiMH gumstick battery and have a similar charging port.

The dock may need to be modified to fit bulkier models that use this charging port.

Additional parts needed:

  • 1x usbc lipo battery charging board
  • 2x 15mm length of 18 gauge solid wire, completely stripped of the outer casing 
  • 4x 50mm length of 18 gauge stranded wire, with the ends stripped, 2 red, 2 black
  • a 3v dc regulator board
  • (optional) 1x lipo battery that will fit in the case with the other components
  • screws for the boards
  • Solder and Soldering iron
  • Hot glue and hot glue gun
  • Continuity tester/minidisc player schematic

 

  1. Solder the output of the lipo charger to the input of the 3v regulator
  2. Solder the optional lipo dock battery to the output of the charger in parallel
  3. Solder each of the small lengths of solid core wire to one of thee red and one of the black wires
  4. Use the soldering iron  at 400F to heat sink the solid wire lengths into the charging port holes in the dock (make sure to check your player's schematic or use a continuity tester to verify which lead should be ground)
  5. Use the hot glue to secure the charging pins
  6. Solder the other ends of the charging pin leads to the output of the DC regulator
  7. Secure the boards to the inside bottom of the case with hot glue or heat set screws
  8. Secure the battery to the inside of the top of the case with hot glue or tape
  9. Pressure fit the two halves of the case together
  10. (Optional) Secure with hot glue
        

Tagi