Left-handed Whammy Bar Mount (Wii Les Paul / Guitar Hero)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Relocate the whammy bar for left-handed play on Wii Les Paul guitars.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 980
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution
Make your Wii Les Paul whammy bar more suitable for left-handed play with this simple recreation of the stock assembly. It consists of three parts: a base plate that's been designed to fit in an empty Wiimote cavity, and two side plates to mount the whammy bar joint housing on the base.
Requirements
- An empty Wiimote slot. This mod is not compatible with adapters that also use this space.
- Flush cutters to remove some plastic on the stock bar mount. Alternatively, print out a new base.
- Double-sided tape or possibly an equivalent like Velcro.
- Soldering iron to rewire the potentiometer.
- Hook-up wire long enough to reach the new mount point.
Installation steps
- Test the fit. The side plates should slide into their respective slots on the base plate (note: it's a tight fit) and the base should fit neatly within the cutout inside the Wiimote cavity.
- Add double-sided tape to the larger flat surfaces on the bottom of the printed base plate.
- Install the base plate in the Wiimote opening. Make sure to route your external connection wire through the rounded wire cutout.
- Replace the potentiometer wiring with wires long enough to reach the Wiimote slot. Be sure to swap the wires on the outer terminals (i.e. the wire going to terminal 1 now goes to 3 and vice versa) since the whammy bar is now moving in a different direction. Route the wires through the same cutout used by the original Wiimote cable (picture below).
- Clip off the plastic tabs on the whammy bar joint that restricts its range of motion in a left-handed setup (picture below).
- You might also need to bend over the tabs on the back of the potentiometer so that it fits within the slot (picture below).
- At this point, you should be able to fully reassemble the whammy bar and slide it into the new mount. It can be kind of annoying to get the sandwiched plate+whammy+plate assembly into place with the bar coming out through the top of the guitar, but you'll eventually get it.
- Load up Santroller and recalibrate the whammy bar.
- Enjoy!


Print settings
I used the following settings on my final print:
- Layer height: 0.2mm
- Support type: Normal
- Infill density: 15%
- Infill pattern: Grid
The base and anchor plates were printed on their flattest sides, while the control plate was printed at an angle as that's how Bambu Studio automatically oriented it. I experimented with tree supports and gyroid infill on previous iterations of the models but found them functionally the same as the settings above.