1 / 2
Neopixel Wallframe for Mirror / Lithophane — zdjęcie 1
1 / 2

Neopixel Wallframe for Mirror / Lithophane

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A backlit wall frame for engraved mirrors or lithophane pictures with individual field colors or lighting sequences.

Ocena
0 / 5
Polubienia
2
Pobrania
11
Wydruki
0
Wyświetlenia
240
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Wall-mounted
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

The frame was designed to backlight 15x15cm engraved mirror tiles. The following print parts are required for this:

  • 4 Corners
  • 1 Mid_Top 
  • 1 Mid_Bottom
  • 4 screw covers
  • 12 connector pins (brim recommended)

You can also use the frame with just the 4 corner parts without lighting. I also glued all the parts together with superglue and glued the mirrors in place.

The following items were also required for the lighting:

  • 5V RGB-LED-Stripe, individually controllable like this (60 LED/m)
  • 5V PSU with on/off switch 
    • Current depends on your led strip, number of LED and the colors
    • In my case 144 pixels, this means around 3A when all pixels glow white, in my case it was around 1A, but better use one, which can handle the worst case.
  • AtTiny85 or a comparable microcontroller
  • 300-500 ohmic resistor in front of the first pixel

The LED strip was installed in the order shown below, but it is also possible to use other ways and also all sides of the fields.

If you are interested in the code for addressing the lights with the AtTiny85, please contact me (this is a bit difficult due to the limited memory of the microcontroller). Otherwise there should be enough space in the housing for a controller with more memory.

Tagi