S1000R SOS button holder no mirror
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
S1000R SOS button holder which replaces the original mirror holder pipe clamp.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 365
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Do you have bar-end mirrors on your S1000R (2021 and up), great look! But now you are stuck with those antenna looking ugly pipe clamp things where the original mirrors used to be. You managed to get rid of the left side because there are parts for it but the right side has a SOS button holder as well can't be replaced as easily. What to do now?!
Fret not my biker friend! This will replace the original pipe clamp, hold the SOS button and cover the top of the button. You can use the original screws to tighten things in place (use anti-slip rubber to tighten it securely).
To screw the SOS button back in place use a M5 threaded insert.
- Printed with Bambu X1C
- 0.20 mm Strength
- Print with ASA filament for best result+durability
- I printed it with 100% infill
- Use Brim and support to make sure everything stays nice and clean during printing
Disclaimer:
Although I have this on my bike for a full year with no issues, please understand that the print can snap and if that happens your brake lever along side of your SOS button might fall off. So, please print and use at your own risk!