Print-in-place 54mm Espresso Portafilter Spinning Leveler/Funnel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A combination funnel and spinning leveler for espresso machines made for multi-material printers
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 39
- Wydruki
- 1
- Wyświetlenia
- 580
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This combination espresso funnel and leveler combines two steps into one. Clip this funnel directly onto a 54mm portafilter to make pouring ground coffee mess-free! Well, less messy; it's still coffee. Then spin the top to level out the bed to provide a smooth and even surface for tamping.
This print is designed to use the incompatibility of PLA and PETG to make several “ring bearings” that allow the blades to spin on top of the stable base. It requires just a little bit of pinching it back and forth after it's done, and it spins freely.
I would like to make versions for other size portafilters and single-material printers soon.
Check out the Short here!