Tamiya TT-02B Rear shock tower (remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed Xlnt3D's nicely designed rear TT-02B shock tower ( https://www.thingiverse.com/thing:4494409 ) so I could use…
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 265
- Wydruki
- 1
- Wyświetlenia
- 1230
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Remixed Xlnt3D's nicely designed rear TT-02B shock tower ( https://www.thingiverse.com/thing:4494409 ) so I could use my stock screws. This is a great replacement to add rigidity to the rear shock tower so your shocks can do their job. This removed a lot of flex. Will also save you $20 or so too if you don't want to spend that on an aluminum tower.
Printed in polycarbonate. 40% infill , 5 outer layers (top/bottom/perimeter). PETG printed at the high end of the specified temp window to ensure solid layer adhesion would work nicely as well. I would not use PLA as it has give over time when under a force.
Print Settings
Rafts:
No
Supports:
No
200
Infill:
20
Filament:
PolyMaker PLA
Category: R/C Vehicles