Oculus Quest 2 Stand - Hex Base (only) Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed this a bit by adding hex holes in the base.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 141
- Wydruki
- 0
- Wyświetlenia
- 1271
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Share Alike
CAUTION
This is ONLY the remixed base, not the rest of the pieces. Make sure to get the rest of the files from the original location. This does not contain anything else.
Original files are here: https://www.printables.com/model/179776-oculus-quest-2-stand
Description
I tried to print the base this in its original design twice but every time I did, the base print would fail because of my support configuration. I had tried printing supports on top of the base. They would instantly delaminate from the top of the base, by design. So I added some hex holes in the base, to give it a unique design, but more to allow the support material to print through the base, and hold up the top structure as it printed. I will note that the support materials still had problems printing toward the back of the base, and I think I came to the conclusion that I didn't need to actually print the supports, as long as I went slow enough (80mm/s), the arch piece would likely print without them.
My print configuration was as follows:
Common Parameters
| Total Print Time | Number of Print Files | Layer Height | Nozzle Diameter | Material |
| 14 hr 11 m | 1x print file | 0.2 mm | 0.40 mm | PLA+ |
Weight / Printer Make & Model / Temps
| Total Weight | Printer | Bed Temp | First Layer Temp | Other Layers Temp |
| 207g | Ankermake M5C | 60° C | 215° C | 215° C |
Infill / Skirt / Brim / Support
| Infill Density | Infill Pattern | Skirt | Brim Width | Support Material |
| 15% | Grid | 2 Loops | 2.5 mm | Yes (Organic; Tree) |
Speeds (mm/s or %)
| Perimeter Speed | Infill Speed | Small Perimeters | External Perimeters | Non-print Travel |
| 80 | 80 | 40% | 50% | 80 |