1 / 4
Bosch Logixx 8 - Door Handle Fix — zdjęcie 1
1 / 4

Bosch Logixx 8 - Door Handle Fix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

On my Bosch Logixx 8 washing machine the door handle was no longer functional and i had to open the door through the…

Ocena
0 / 5
Polubienia
1
Pobrania
38
Wydruki
0
Wyświetlenia
251
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

On my Bosch Logixx 8 washing machine the door handle was no longer functional and i had to open the door through the emergency opening all the time. When opening the door i found that a little part has broken off. This part is wrongly designed and is way too small for the load that is imposed on it. Therefore this printed part reinforces the section and allows the door to be used normally again.

Post-Printing

Step 1: Clear remains of broken piece on door handle

To fit the printed part, you have to have a smooth surface. Therefore remove all remains of the broken part on the door handle

Step 2: Drill through into the plastic of the door handle

Hold the printed part into the final position and drill through the two holes into the door handle. Use a drill which is a bit smaller than your screws

Step 3: Mount Printed part

Finally screw the printed part to the door handle.

How I Designed This

I used OpenScad to design the part with the excellent screw hole library from here.

Tagi