Ender 3 V3 SE 5015 Fan upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting for 5015 fan to ender 3 v3 SE with dual side blowing point
- Ocena
- 4,857 / 5
- Polubienia
- 453
- Pobrania
- 3058
- Wydruki
- 42
- Wyświetlenia
- 17 029
- Oceny
- 35
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
________________________________________________________________________________________________________________
My other Ender 3 V3 SE mods
Fan mods:
Printer mods:
________________________________________________________________________________________________________________
About project:
Ender's 3 V3 SE mount for 5015 fan, greatly increases performance, helps with noise reduction and reduces stringing due to dual sided blowing ducts.
Needed parts:
- 3 M3 bolts
- M3x20 bolt (recommended)
- M3 heatset insert (recommended)
- 1,25 JST connector
Printing:
Here's recommended placing on bed with supports:
Assembly:
Whole mount is adjustable, its good to take your time while mounting it to make sure its placed correctly.
________________________________________________________________________________________________________________
NEW UPDATE
- Redesigned from start to end
- Improved airflow
- More centered airflow compared to V1
- Lighter (just 20g)
- More compact design
- Sturdier
Here's the blowing difference, same fan, both 100% power.
________________________________________________________________________________________________________________
If you like what im doing, please consider leaving a tip :D that helps me a lot, Thanks!
https://ko-fi.com/0x53_